+44 (0) 116 367 0533

Vialle LSi: Injector Nozzle Set (D)

(1 review) Write a Review
0.50 KGS
Calculated at Checkout
£18.99 Inc. VAT


Vialle LSi: Injector Nozzle Set (D)

Injector Nozzle with mountig accessories and pipe.

Set is dedicated for a single Vialle LSi injector.

Thread on the manifold needs to be M10x1



The nozzle set contains the injection nozzle and all necessary parts for fitting them and connecting the fuel lines. The nozzle has the task of conducting the high velocity LPG droplets from the injector tip to airstream flowing through the intake manifold. You can either mount the injectors directly onto the nozzles or mount the injectors in a remote location using part or the full length of the supplied pre‐installed nozzle (extension) tubes.  The distance between injectortip and inlet valve should be as short as possible to ensure optimal driveability.



a) The nozzles are installed by drilling a 8,5 [mm] hole in the intake manifold, as close as possible to the cylinder head. Use a M10x1 thread cutter to create the required threading for the nozzles.

b) Upon installation of the nozzles apply a modest amount of sealant to the nozzle thread. This will assure an air tight installation and also prevent unintended loosening of the nozzles. Screw in the nozzle and place the nozzle exit opening as deep into the middle as possible.

c) Turn the nozzle with the nozzle exit opening facing towards the center of the manifold channel.

Secure the Nozzle with the M10x1 nut.


If you use the remote injector placing:

  • make sure that you keep the length of the nozzle lines to a minimum.  
  • make sure that all nozzle lines are kept at an equal length.  


After installation:

  • Check orientation of nozzle (position of the indicator dot) 
  • Check for leakage after the system is completely installed and operational




1 Review

  • 5

    Posted by Uldis Valdmanis on 17th Feb 2019